Denon Stereo Receiver Denon AVR-X4000 Integrated Network AV Receiver User Manual

0

Out of 0 Ratings

Owner's of the Denon Stereo Receiver Denon AVR-X4000 Integrated Network AV Receiver gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 275
 
216
Appendix
SettingsPlaybackConnections
Contents
Front panel Display Rear panel IndexRemote
Tips
Symptom Cause/Solution Page
DTS sound is not output. •Check that the digital audio output setting on the connected device is set to “DTS”.
•Set “Decode Mode” on the menu to “Auto” or “DTS”.
–
171
Dolby TrueHD, DTS-HD, Dolby Digital
Plus audio is not output.
•Make HDMI connections.
•Check the digital audio output setting on the connected device. On some devices, “PCM” is
set by default.
41,42
–
Dolby PLg mode or DTS NEO:X mode
cannot be selected.
•It cannot be selected when “None” is set for “Speaker Config.” – “Center” and “Surround”.
•These cannot be selected when using the headphones.
182
–
Audyssey MultEQ® XT32, Audyssey
Dynamic EQ®, Audyssey Dynamic
Volume® and “Audyssey LFC™”
cannot be selected.
•These cannot be selected when you have not performed Audyssey® Setup.
•Switch the sound mode to other than “DIRECT” or “PURE DIRECT”.
•These cannot be selected when using the headphones.
172
114
–
Audyssey DSX® cannot be selected. •It can be selected when using the front height or front wide speakers.
•It can be selected when using the center speaker.
•Switch the sound mode to DOLBY sound mode or DTS sound mode.
•This cannot be selected when using the headphones.
184
182
113
–
“Restorer” cannot be selected. •Check that an analog signal or PCM signal (Sample Rate=44.1/48 kHz) is input. For playback
of multichannel signals such as Dolby Digital or DTS surround, “Restorer” cannot be used.
•Switch the sound mode to other than “DIRECT” or “PURE DIRECT”.
155
114
No audio is output from PRE OUT or
speakers for ZONE2/ZONE3.
•In ZONE2/ZONE3, the audio can be played back when signals input from digital connectors
(OPTICAL/COAXIAL) are in 2ch PCM format.
•In ZONE2, the audio can be played back when signals input from the HDMI connector are
in 2ch PCM format. To play back the audio in ZONE2 irrespective of the input signal format,
set the “HDMI Audio” setting in the menu to “PCM”. Depending on the played back device,
the audio may not be played back even with this setting. In that case, set the audio format to
“PCM” on the played back device.
–
194

   Find Your Products By Category