Denon Car Satellite TV System Denon Car Satellite TV System User Manual

0

Out of 0 Ratings

Owner's of the Denon Car Satellite TV System Denon Car Satellite TV System gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 227
 
167
Specifying the zone used with the
remote control unit
When the ZONE SELECT button is pressed, only the set zone can be
operated with the remote control unit.
•The factory setting is “M234”.
1
Press and hold RC SETUP for at
least 3 seconds.
“SETUP” and indicator flashes twice
on the remote control unit.
2
Use ui to display “ZLOCK” on
the remote control unit and press
ENTER.
3
Use ui to set the zone to be used
and press ENTER.
“OK” flashes four times on the remote
control unit and the normal operation
mode is restored.
Remote control unit
display
Zone to be used
M MAIN ZONE only
M2 MAIN ZONE / ZONE2
M23 MAIN ZONE / ZONE2 / ZONE3
M234
MAIN ZONE / ZONE2 / ZONE3 /
ZONE4
Setting the Remote ID
When using multiple DENON AV receivers in the same room, make
this setting so that only the desired AV receiver operates.
•The factory setting is “ID-1”.
1
Press and hold RC SETUP for at
least 3 seconds.
“SETUP” and indicator flashes twice
on the remote control unit.
2
Use ui to display “RC-ID” on
the remote control unit and press
ENTER.
3
Use ui to set the remote ID and
press ENTER.
“OK” flashes four times on the remote
control unit and the normal operation
mode is restored.
Remote control unit display Remote ID
ID-1 1
ID-2 2
ID-3 3
ID-4 4
NOTE
When you change the remote ID, make sure that the remote
control unit and the remote ID of the main unit are exactly the same
(vpage152 “Remote ID”).
Setting the display time length of
the remote control unit display
Use the following procedure to set the length of time for which to
display data such as zone and mode on the display panel of the remote
control unit.
1
Press and hold RC SETUP for at
least 3 seconds.
“SETUP” and indicator flashes twice
on the remote control unit.
2
Use ui to display “DISPL” on
the remote control unit and press
ENTER.
3
Use ui to set the display time
length and press ENTER.
“OK” flashes four times on the remote
control unit and the normal operation
mode is restored.
Remote control unit display Display time
05SEC 5 sec
10SEC 10 sec
15SEC 15 sec
Basic version
Advanced version
Informations
Advanced version
DVD

   Find Your Products By Category