Denon Car Satellite TV System Denon Car Satellite TV System User Manual

0

Out of 0 Ratings

Owner's of the Denon Car Satellite TV System Denon Car Satellite TV System gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 227
 
99
1
Set up the zone mode
Press ZONE SELECT to switch the zone mode.
The J indicator lights.
Press ZONE SELECT
NOTE
When using a remote control with preset codes registered
(vpage160), press AVR to set the remote control to the AVR-
operation mode before operation.
2
Connect the setup microphone.
Audyssey Setup
Channel Select
Amp Assign
Check Results
Restore...
Start
Your AV receiver can automatically measure the acoustics of
your room then optimize your speakers using the included
microphone.
Set the following items
if necessary.
When the setup microphone is
connected, the following screen is
displayed.
Set up speakers
around items indicate the settings.
This section describes detailed settings for Audyssey
®
Setup.
First install and connect the speakers to this unit.
Before Audyssey
®
Setup measurement, the settings shown below can be made.
•Changing the amplifier assignment (Amp Assign)
The signal output from the SURROUND BACK, FRONT HEIGHT and FRONT WIDE speaker terminal of this unit can be switched to match your speaker environment (vpage99 “Set up “Amp Assign””).
•Setting the channels to be used (Channel Select)
If channels that are not to be used are set in advance, measurement for the set channels is skipped, and measuring time can be reduced. You can also change the number of surround back speakers (vpage101
“Set up “Channel Select””).
3
Set up “Amp Assign”
Use ui to select “Amp Assign”, and then press
ENTER.
Amp Assign [1/2]
Assign Mode
Main Speakers
Front
Center
Surround
Surr. Back
Front Height
Front Wide
ZONE2
ZONE3
Speaker
Speaker
Speaker
Auto Spkr
Auto Spkr
Not Used
Speaker
Pre-amp out
7.1ch + ZONE2
S.Back/F.Height
ZONE2: ZONE3:
Selects how to use the internal amplifiers
Audyssey Setup
Channel Select
Amp Assign
Check Results
Restore...
Start
Your AV receiver can automatically measure the acoustics of
your room then optimize your speakers using the included
microphone.
Set the following items
if necessary.
4
Select “Assign Mode”, and then press ENTER.
Basic version
Advanced version
Informations
Advanced version
v See overleaf
DVD

   Find Your Products By Category