Panasonic Blu-ray Player Panasonic Blu-ray Player User Manual

2.6

Out of 1 Ratings

Owner's of the Panasonic Blu-ray Player Panasonic Blu-ray Player gave it a score of 2.6 out of 5. Here's how the scores stacked up:

  • Reliability

    1.0 out of 5

  • Durability

    5.0 out of 5

  • Maintenance

    1.0 out of 5

  • Performance

    5.0 out of 5

  • Ease of Use

    1.0 out of 5
of 48
 
Reference
37
VQT3V91
Messages
The following messages or service numbers
appear on the television or unit’s display.
Cannot play.
¾ You inserted an incompatible disc (Discs
recorded in PAL video, etc.).
Cannot display on this unit.
¾ You tried to play a non-compatible image.
¾ Confirm “SD” on the unit’s display is not
displayed and re-insert the card.
No disc inserted.
¾ The disc may be upside down.
$ This operation is not available.
¾ Some operations are unsupported by the unit.
For example;
– BD-Video: During playback, reverse slow
motion or reverse frame-by-frame is not
possible.
IP address is not set.
¾ The “IP Address” in “IP Address/DNS
Settings” is “---. ---. ---. ---”. Set the “IP
Address”, “Subnet Mask”, and “Default
Gateway”. (Select the automatic address
acquisition if necessary.)
The current wireless network security setting
is weak. It is recommended to change to a
stronger security setting.
¾ Authentication type for the wireless LAN is set
to “Open system”, or the encryption type is
set to “No encryption”. It is recommended to
encrypt for safety reasons. For details, refer
to the instructions of the wireless router being
used. Encryption is required when playing
back video, etc., from DLNA compatible
devices.
F99
¾ The unit fails to operate properly. Press [Í/I]
on the main unit for 3 seconds to switch the
unit to standby, then switch back on.
HDMI ONLY
¾ Some BD-Video discs can only be output with
HDMI.
NET
¾ While connecting to a network.
No PLAY
¾ There is a viewing restriction on a BD-Video
or DVD-Video. (> 32)
No READ
¾ The media is dirty or badly scratched. The
unit cannot play.
PLEASE WAIT
¾ The unit is carrying out an internal process.
This is not a malfunction. You cannot operate
the unit while “PLEASE WAIT” is displayed.
REMOVE
¾ The USB device is drawing too much power.
Remove the USB device.
SET (“” stands for a number.)
¾ The remote control and main unit are using
different codes. Change the code on the
remote control.
Press and hold [OPTION] and the following
button at the same time for more than
5 seconds depending on the indication.
SET 1: [G]
SET 2: [B]
SET 3: [Y]
U59
¾ The unit is hot.
The unit switches to standby for safety
reasons. Wait for about 30 minutes until the
message disappears.
Select a position with good ventilation when
installing the unit.
On the television
On the unit’s display
DMP-BDT500_VQT3V91_eng.book 37 ページ ２０１２年２月１４日　火曜日　午後１時９分

   Find Your Products By Category