Onkyo Laser Pointer Onkyo Wireless Music System User Manual

0

Out of 0 Ratings

Owner's of the Onkyo Laser Pointer Onkyo Wireless Music System gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 36
 
En-15
Basic Operation—Continued
Note:
Tone adjustments (Bass, Treble, S.Bass) do not affect the
headphones.
1
Press the [TONE] button to make the
display indicate “Tone Control.”
The value of the Bass setting will blink.
2
Use the []/[] buttons to adjust the value.
You can adjust the value in the range of –3 to +3.
Note:
If you press no buttons for eight seconds, the
previous display will appear automatically.
3
Press the [ENTER] button.
The value of the Treble setting will blink.
4
Use the []/[] buttons to adjust the value.
You can adjust the value in the range of –3 to +3.
Note:
If you press no buttons for eight seconds, the
previous display will appear automatically.
5
Press the [ENTER] button.
The original display will reappear.
To turn on Super Bass, press the [S.BASS] button.
The “S.BASS” indication will appear on the display.
The strength of the ultra-low range will change each time
you press the [S.BASS] button.
The “S.BASS” indication will disappear when this
setting is off.
You can connect a pair of stereo headphones (ø3.5 mm,
1/8-inch phone plug) to the ABX-N300’s headphones
[] jack (see page 11) for private listening.
Notes:
• Always turn down the volume before connecting your
headphones.
• If headphones are connected, no beep will be heard
when you operate the touch screen of the ABX-N300.
• While the headphones plug is inserted in the
headphones [] jack, the speakers are turned off.
• If the input is set to iPod or Rocketboost™ (North
American models only), no sound will be output from
the headphones. Disconnect the headphones and listen
via the speakers.
You can silence the beep tone that is heard when you
operate the touch screen of the ABX-N300.
1
While the ABX-N300 is in standby mode,
press the remote controller’s [MENU]
button.
2
Use the []/[] buttons to select “Beep,”
and press the [ENTER] button.
3
Use the []/[] buttons to select “Off,” and
press the [ENTER] button.
Tip:
If you want to re-enable the beep tone, choose “On” in
step
3
of the procedure above.
Adjusting the Bass and Treble
(remote controller only)
Using Super Bass
(remote controller only)
S
.
BASS
S.Bass Off
S.Bass On
(default setting)
Using Headphones
Silencing the beep tone during
operation (remote controller only)

   Find Your Products By Category